Brake Rod Replacement - Big Wheel Only - Stryker 1037 Manual De Instrucciones

BRAKE ROD REPLACEMENT - BIG WHEEL ONLY

Tools Required:
• Hammer
• 7/32" #7 Roll Pin Punch
• Needle Nose Pliers
• Bungee Cords
Procedure:
1 . Pump the stretcher all the way up .
2 . Raise both siderails to the up and latched position .
3 . Using bungee cords, support the raised base hood .
4 . Put the brake/steer pedal into the steer position .
5 . Using a hammer and a 7/32" roll pin punch, remove the two roll pins from pedal to pedal on the brake rod .
6 . Using needle nose pliers, remove the five rue clips and clevis pins from the brake rod . Save all parts for reinstallation .
Note: If the unit has four-sided brakes, there will be a sixth rue clip and clevis pin to remove .
7 . Using a 5/32" Allen wrench, loosen the set screw on the head end brake rod stop collar .
8 . Remove the brake rod from the base .
9 . Reverse steps to install the new brake/steer pedal assembly .
10 . Verify proper operation of the unit before returning it to service .
www.stryker.com
Service Information
1037-009-006 REV D
Return To Table of Contents
1-19
English