Rollplay BMW R1200 GS Motorcycle Instrucciones De Montaje página 7

19. Protective equipment should be worn.
20. Exhausted batteries are to be removed from the toy.
21. Rechargeable batteries are to be removed from the toy before being
charged.
1a 1b
2. A
ssemble the rear wing bracket (Fig 2)
Align the slot on the rear wing bracket with rear fork, tighten them with self
tapping screw.
3. Assemble rear wheel (Fig 3)
1）Attach the gear box (keep the side with motor face outwards) on rear wing
bracket, push rear axle through the hole on gear box. Align the hole on gear box
with the hole on rear fork left arm and x with a self-tapping screw.
2）Insert rear axle into the hole on the rear fork left arm and gear box, connect
gear box and battery connector, push rear axle through rear wheel, then pass the
axle through a washer, an axle bushing to nish the assembly.
Note: gear box against the boss on one side of rear wheel）fork right arm.
4. Assemble the supporting wheel (Fig 4)
Insert the left support wheel into the left side of rear axle, insert the right
supporting wheel and rear axle cover into the right side of rear axle in order,
then insert the back shield into the left side of rear axle, align the two slots on
back shield with the protrude on the body (Fig 4a), press the back shield until
hear a click, then screw a screw into back shield. Insert a washer and hexagon
nut on both sides of rear axle, tighten them with wrench.
5. Assemble rear wing : (Fig 5)
Align the slot on the rear wing with the boss of the rear wing bracket, and insert
the boss into the hole of the slot to complete the assembly.
6. Assemble the license plate: (Fig 6)
Align the top slot on the license plate with the bottom slot on the rear of the
chassis. Press the license plate until you hear a click to complete the assembly.
7. Assemble the handle bar: (Fig 7)
Screw out the square nut and M5 machine screws from the front fork, and then
insert the handle bar into the front fork, align the slot on the handle bar with the
slot on the front fork, tighten them with M5 machine screws and square nut,
make the connector of the handle bar through the slots of body, then connect
the connectors of handle bar and body. Ensure the connectors are not damaged
during assembly.
o
10. Disassemble the seat: (Fig 10)
Remove the seat, turn the screw of the seat to open position, and lift the seat.
11. Assemble the baggage holder: (Fig 11)
Align the two buckles on the baggage holder with the slots on the tail end of
the chassis. Press the baggage holder until you hear a click to complete the
assembly. Use a self tapping screw to secure.
12. Assemble the battery: (Fig 12)
Connect the battery connector to the connector on the body near the
battery compartment. Store the wires and connectors next to the battery.
Fix the seat over the battery compartment; rotate the screw of the seat to the
lock position.
Press the button on the front of the handle bar to start the car, and the
button will light up.
Press the button on handle bar to hear sounds.