Network Administration Software; System Requirements; Installing Software - Ricoh Aficio SP 5100N Guía Rápida

Network administration software

The CD-ROM supplied with your printer card provides you with:
• SetIP: A utility program allowing you to select a network printer card and
manually configure the addresses for use with the TCP/IP protocol.

System requirements

To install SetIP, the following are required:
• Operating system: Windows 2000/XP/2003
• Computer/Processor: 133 MHz or faster Pentium-compatible processor
• Memory: 256 MB (recommended)
• Hard Disk: 2 GB hard disk with 1.5 GB available hard-disk space
• Internet Explorer 5.5 or later, or Mozilla 1.0

Installing software

1
Insert the supplied CD-ROM into your CD-ROM drive.
2
The CD-ROM will automatically run. If it does not, click Start
enter x:/cdsetup.exe (x represents your CD-ROM drive), and click OK.
3
Select the language you want.
4
Click Install SetIP.
5
Follow the onscreen instructions to complete installation.
6
Click Finish when installation is done.
3
Run,