Clean Detergent Siphoning Tube; Automatic Cool Down System (Thermal Relief); Optional Accessories (Not Included With All Models); Powerdial™ Gun (If Equipped) - Generac A0001468710 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5. Spray gun may kick back when using high
pressure spray. Firmly grasp spray gun
with both hands to avoid injury.
6. Apply a high-pressure spray to a small
area and then inspect surface for damage.
If no damage is found, continue rinsing.
7. Start at top of area to be rinsed, working
down with same overlapping strokes as
used for cleaning.
Clean Detergent Siphoning
Tube
Flush detergent siphoning tube after each use
before stopping the engine.
1. Place detergent siphoning tube/filter in
bucket of clean water.
2. Remove high-pressure nozzle from lance.
3. Select and install black detergent nozzle.
4. Flush for 1-2 minutes.
5. Turn engine OFF.
6. Point spray gun in a safe direction,
squeeze spray gun trigger to release
retained high water pressure. Engage
trigger lock.
After Each Use
DO NOT allow water to remain in unit for long
periods of time. Sediments or minerals can
deposit on pump parts and freeze pump.
Follow these procedures after every use:
1. Turn engine OFF.
2. Turn fuel valve OFF.
3. Turn water supply OFF.
4. Point spray gun in a safe direction, and
squeeze
trigger
pressure.
5. Let engine cool.
6. Disconnect hoses from spray gun and
high-pressure outlet on pump. Drain water
from hoses, spray gun, and lance. Use a
rag to wipe off components.
7. Pull recoil handle approximately six times
to remove remaining liquid from pump.
8. Store unit in a clean, dry area.
NOTE: If storing for more than 30 days, see
Storage.
Automatic Cool Down System
(Thermal Relief)
When the power washer runs for 3-5 minutes
without spray gun activation, circulating water
in pump can reach a temperature sufficient to
engage the thermal relief system. The pump is
cooled by discharging water onto ground.
Owner's Manual for Power Washer
to
relieve
trapped
Optional Accessories (not
included with all models)
Soap Blaster
Use soap or detergent for better cleaning
results.
1. Pre-rinse area with green or white nozzle.
2. Attach soap blaster nozzle to lance.
3. Add soap to tank (as directed by soap
manufacturer).
4. Connect siphon hose to pump and insert
into soap tank.
5. Select soap setting on PowerDial™ gun.
6. Apply soap starting from bottom to top of
surface area.
Turbo Nozzle
Use for cleaning hard surfaces.
1. Attach turbo nozzle to lance.
2. Select
appropriate
PowerDial™ gun.
3. Start with tip 3 ft (1 m) away from work
area*.
4. Work from top to bottom of surface area.
NOTE: *Use with caution on softer surfaces.
Power Broom
Use for cleaning large surfaces like decks and
driveways.
1. Attach power broom to lance.
2. Select
appropriate
PowerDial™ gun.
3. Make overlapping passes to prevent
streaking.
PowerDial™ Gun (if equipped)
WARNING
Consult Manual. Read and understand manual
completely before using product. Failure to
completely understand manual and product
could result in death or serious injury.
1. Make connections according to
High-Pressure Hose and Lance
owner's manual.
2. Adjust PowerDial™ according to the task
being performed.
3. Operate according to
owner's manual.
Operation
task
setting
on
task
setting
on
(000100a)
Connect
in the
Spray Gun
in the
11

Publicidad

Tabla de contenido
loading

Tabla de contenido