Section 3: Operation; Operation And Use Questions; Before Starting Engine; Prepare Power Washer For Use - Generac A0001468710 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operation

Section 3: Operation

Operation and Use Questions

Call Generac Customer Service at 1-888-
GENERAC (1-888-436-3722) with questions
or
concerns
about
maintenance.

Before Starting Engine

Unit is shipped with no oil in the
crankcase. Add engine oil before starting.
See
Engine Oil Recommendations
1. Verify engine oil level is correct.
2. Verify fresh fuel level is correct.
3. Verify all fittings and couplers are correctly
secured.
4. Verify sufficient water supply is correctly
connected.
5. Verify thermal relief valve is rotated and
open to ground.
6. Verify unit is secure on level ground, with
correct clearance and is in a well
ventilated area.
NOTE: The Lithium-ion battery comes partially
charged from the factory. Some batteries may
not have enough energy to start the engine
initially. Charge the battery fully before the
initial use. To charge the battery, see
Maintaining the
Battery.

Prepare Power Washer for Use

1. Place unit on level ground, within the
specified clearance required.
2. Connect appropriate water supply.
Power Washer Placement for Use
DANGER
Asphyxiation. Running engines produce carbon
monoxide, a colorless, odorless, poisonous
gas. Carbon monoxide, if not avoided, will
result in death or serious injury.
WARNING
Risk of Fire. Hot surfaces could ignite
combustibles, resulting in fire. Fire could
result in death or serious injury.
WARNING
Hot Surfaces. When operating machine, do not
touch hot surfaces. Keep machine away from
combustibles during use. Hot surfaces could
result in severe burns or fire.
8
unit
operation
and
(000103)
(000110)
(000108)
It is a violation of California Public Resource
Code, Section 4442, to use or operate the
engine on any forest-covered, brush-covered,
or grass-covered land unless the exhaust
system is equipped with a spark arrestor, as
defined in Section 4442, maintained in
effective working order. Other states or federal
jurisdictions may have similar laws.
Only operate power washer outdoors in a well
ventilated area. Never operate power washer
indoors, or in a confined space. Be aware of
building openings and ventilation systems
where exhaust may enter during use.
• Verify power washer is placed on level
ground to avoid tipping during operation.
• Only use the unit outdoors. Verify exhaust
gas does not enter a confined area through
windows, doors, or ventilation intakes.
• See
3-1. Keep at least 5 ft (1.5 m) of
Figure
clearance on all sides of power washer
including overhead from dwellings and
combustibles, when in use.
Figure 3-1. Five Feet of Minimum
Clearance
Transporting/Tipping of the Unit
WARNING
Personal Injury / Equipment Damage. Place wand/gun
in holster and verify that handle is locked into place
before moving. Failure to do so could result in death,
serious injury, or equipment damage.
Do not operate, store or transport the unit at
an angle greater than 15 degrees.
Owner's Manual for Power Washer
001643
(000244a)

Publicidad

Tabla de contenido
loading

Tabla de contenido