General Information and Setup
3. See
Figure
2-3. If accessory nozzles (soap
blaster or turbo nozzle) are included
attach accessory nozzle holder to either
side of billboard using supplied screw (A)
and hex key (B).
A
Figure 2-3. Accessory Nozzle Holder
4. See
2-4. Install gun hook (A) on
Figure
right (back) side of handle. Secure with
tree clip (B).
B
A
Figure 2-4. Install Gun Hook
5. See
Figure
2-5. Insert and snap nozzles
into spaces provided in handle.
Figure 2-5. Insert Nozzles
6. See
Figure 2-6
to install battery.
4
B
Add Engine Oil
Unit is shipped with no oil in the engine.
012516
Add engine oil before starting. See
Recommendations.
1. Place power washer on a level surface.
2. Verify oil fill area is clean.
3. Remove oil fill cap/dipstick and wipe
dipstick clean.
012429
4. Add recommended engine oil.
NOTE: Some units have more than one oil fill
location. It is only necessary to use one oil fill
point.
5. Thread dipstick into oil filler neck. Oil level
is checked with dipstick fully inserted.
6. See
oil level is within safe operating range.
001621
001621
7. Install oil fill cap/dipstick and hand-tighten.
Figure 2-6. Install Battery
Figure 2-7. Remove Dipstick
Figure
2-8. Remove dipstick and verify
Figure 2-8. Safe Operating Range
Owner's Manual for Power Washer
012430
Engine Oil
000115
000116