Working; Extracting Dry Materials; Extracting Wet Materials/Liquids; Exhaust-Air Outlet - Festool CTL MINI I Manual De Instrucciones Original

Ocultar thumbs Ver también para CTL MINI I:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 29
LED lights up red
► Switch off the mobile dust extractor, let it
cool down.
► Switch on the mobile dust extractor again
after approx. five minutes.
7.3
Locking the brake [1A]
► Raise the front of the mobile dust extractor
slightly.
► Push down the brake [1-13] until it engages
into position.
► Actuate the button [1-12] to release it.
7.4
SysDoc
WARNING
Risk of injury
► Do not stand on the storage area of the
mobile dust extractor.
CAUTION
Risk of injury
► Ensure that the T-Loc or the four SysDoc
locks are closed during transport.
A Systainer can be fastened to the storage
area [1-7] with the T-Loc lock [1-8]. Systainers
without T-Loc can be secured with the four Sys­
Doc locks [1-3].
8

Working

8.1

Extracting dry materials

CAUTION
Hazardous dust
Damage to the respiratory passage
► Always use a filter bag!
► Check that the main filter is undamaged
before extracting.
When extracting dust that exceeds the
limit value, only extract from one dust
source (power or compressed-air tool).
Observe the following when extracting dust
generated by operating power tools:
Ensure there is adequate ventilation! Observe
regional regulations!
Limit values: Exhaust air max. 50% of the fresh
air volume
Equation: Room volume V
L
W
Excessive temperature
x air renewal rate
R
8.2

Extracting wet materials/liquids

Remove the filter bag!
Use a special wet filter.
The dust extractor stops automatically when
the maximum fill level is reached.
The bottom LED [1-18] lights up red.
► Switch off the mobile dust extractor [1-11].
► Open the locking clips [1-10] and remove
the top section of the machine.
► Empty the dirt trap [1-9].
After wet extraction, allow the main filter to dry!
Dry the mobile dust extractor before extracting
dry dust.
CAUTION
Hazardous dust
Damage to the respiratory passage
► After extracting wet materials, remove the
wet filter and replace it with the main filter
for dry materials.
CAUTION
Escaping foam and fluids
► Switch off and empty the machine immedi­
ately.
8.3

Exhaust-air outlet

CAUTION
Hazardous dust
Damage to the respiratory passage
► Do not blow off any dust!
The exhaust-air outlet offers the option of di­
verting the exhaust air outside a building using
the suction hose.
► Open the grille in front of the exhaust open­
ing [1-14].
► Insert the suction hose in the exhaust open­
ing [1-14].
8.4
Cleaning the filter and filter bag
manually
► In standby mode, press the MAN but­
ton [1-17].
► Set the suction power to the maximum set­
ting [1-18].
► Cover the suction hose with your hand while
at the same time briefly pressing down the
cleaning lever [1-16] three times.
English
19

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ctl midi iCtl miniCtl midi

Tabla de contenido