Wi-Fi Protected Setup - Cisco Linksys WET610N Guia Del Usuario

Linksys WES610N/WET610N
Passphrase Enter the key shared by the bridge and wireless router or access
point It must have 8-63 characters
Click Save Settings to apply your changes, or click Cancel Changes to cancel
your changes
WEP
WEP is a basic encryption method, which is not as secure as WPA or WPA2
Encryption Select a level of WEP encryption, 40/64 bits (10 hex digits) or
104/128 bits (26 hex digits) The default is 40/64 bits (10 hex digits)
Key 1 Enter the WEP key of your network
Tx Key Key 1 is the transmit key used by the bridge
Authentication The default is Auto, which allows either Open system or Shared
key authentication to be used Select Open to use open system authentication;
the sender and recipient do not use a WEP key for authentication Select
Shared to use shared key authentication; the sender and recipient use a WEP
key for authentication
Click Save Settings to apply your changes, or click Cancel Changes to cancel
your changes

Wi-Fi Protected Setup

There are two methods available Use the method that applies to the router
you are using
Method #1
Use this method if your router has a Wi-Fi Protected Setup button
1. Click or press the Wi-Fi Protected Setup button on the router
2. Within two minutes, click the Wi-Fi Protected Setup button on the
bridge's Wi-Fi Protected Setup screen
3. After the bridge has been configured, click Close
The Wi-Fi Protected Setup screen displays the Link Status, Network Name (SSID),
and Security method
Advanced Configuration
9