Ports Panel - Cisco Linksys WET610N Guia Del Usuario

Linksys WES610N/WET610N

Ports panel

WES610N
Ethernet The Ethernet port(s) connects the bridge
to a computer or other Ethernet network device The
WES610N has four ports, and the WET610N has a single
port
Reset There are two ways to reset the bridge's factory
defaults Either press and hold the Reset button for
approximately five seconds, or restore the defaults
from Administration > Factory Defaults in the bridge's
browser-based utility The WES610N has a reset button
on the bottom, and the WET610N has a reset button on
the back port panel
Power The Power port connects the bridge to the
included power adapter
WET610N
Product Overview
3