Air Circulation - Tectro TP 1020 Instrucciones De Uso

All manuals and user guides at all-guides.com
Insert the plug into the wall outlet.
Press the -button to switch on the air conditioner. The air conditioner
starts in the automatic mode:
• If the ambient temperature is higher than 23ºC, the unit will work in
cooling mode.
• If the ambient temperature is < 23ºC, the unit will work in air circulation
mode.
With -button you can change the operating mode of the unit.
By pressing the -button the following modes appear:
Automatic mode
Cooling mode
Air circulation mode
cOOling
When the unit is in the cooling mode, the following functions apply:
• The fan speed can be adjusted by pressing the
Maximum setting.
Lowest setting.
• The temperature can be set by pressing the
between 18°C en 32°C. The display will show the set temperature for 8
seconds and the "set temp" will light up. Fifteen seconds after setting
the required temperature, the display will show the room temperature.
In auto mode, the unit will choose the ventilation speed automatically
according to the ambient temperature. The speed switch cannot be
changed in this mode.
G
It depends on the environment whether the required temperature will
be reached. It is not a malfunction of the air conditioner if the room
temperature remains above the "set temp". It could well be that the
heat load of the room is too much.

Air circulAtiOn

In this mode the unit only circulates air; the unit will not cool or dehumidify.
The air is filtered.
When the unit is in this mode, the following functions apply:
• The fan speed can be adjusted by pressing the
Maximum setting.
Lowest setting.
In auto mode, the unit will choose the ventilation speed automatically
according to the ambient temperature. The speed switch cannot be changed
in this mode.
When the unit is switched off the most recent setting will be stored in
memory.
-button
and buttons, anywhere
-button
4
71