Remote Control - Tectro TP 1020 Instrucciones De Uso

1.
2.
G
G

remOte cOntrOl

A
a.
E B
b.
D B
c.
d.
C
e.
F
f.
The remote control works in combination with the control panel. Aim the front
end of the remote control at the control panel. The maximum operating distance
from the air conditioner is approximately 5 metres. Place 2 pieces of AAA Batteries
before use.
4
72
All manuals and user guides at all-guides.com
The timer function allows you to switch the unit on or off at a certain time.
Press TIMER button to set the operating hours you desired (1 to 12 hours,
the timer indicator will light on). When the set time has been reached, the
machine will turn off automatically. The display window will show the hour(s)
you set as you press TIMER button. If the timer button is not pressed, the unit
will work continuously.
By pressing the timer but without turning on the other functions, you can
PRE-SET the time for the machine to work. For example, if you press the timer
to '2', the unit will work automatically after 2 hours.
nOte!
The compressor has been set so that it starts functioning three minutes
after the (re)start of the air conditioner. The cooling will switch off
when the room temperature is lower than the set temperature. Air
circulation will however continue to work on the set level. When the
room temperature rises above the set temperature, the cooling will
work again.
SleeP mOde
By pressing the Sleep button, the set temperature will increase 1ºC at the first
hour, another 1ºC at the second hour. The unit will then keep its temperature.
The ventilation will remain at low speed.
After pressing the sleep button again, the set temperature and ventilation
speed will return to the pre-selected one.
When in sleep mode the unit will shut down automatically after 12 hours.
nOte!
This function is not available in the Auto or Fan mode.
Power on/off button
Temperature +/- buttons
Fan Speed button
Timer button
Function button
Sleep button