Página 1
HLT1 INSTRUCTION MANUAL Para Español ver página 14 WE’RE HERE TO HELP Want to watch a Get it right the Our US-based Recommended placement video that shows first time. install experts how easy this DIY HeightFinder ™ are standing project will be? shows you by to help.
Página 2
130 lbs. Yes — This mount is NOT compatible. weigh more than (58.9 kg) 130 lbs. (58.9 kg)? Visit sanus.com or call 888-384-1115 to find a compatible mount. What is your Drywall with Solid concrete or Unsure? wall made of?
Página 4
Parts and Hardware M5 x 12mm M6 x 12mm M8 x 16mm M8 x 20mm M5 x 12mm M8 x 16mm M4 x 12mm M6 x 12mm M8 x 20mm WARNING: M5 x 12mm M8 x 16mm M4 x 12mm M6 x 12mm This product contains small items that could be a choking hazard if swallowed.
Página 5
M5 x 12mm M8 x 16mm M4 x 12mm M6 x 12mm M8 x 20mm Parts and Hardware for STEP 2 Concrete Installation Kit CMK1 (NOT INCLUDED) M6 x 35mm Wall Plate Template M8 x 35mm Contact Customer Service at 888-384-1115 to have these additional pieces shipped directly to you.
Página 6
STEP 1 Attach Brackets to TV Standard configurations 1.1 Select TV Screw Diameter 1.2 Select TV Screw Length are shown. For special applications, or if you Hand thread screws into the threaded inserts If your TV has a flat back AND you want your TV closer to are uncertain about your on the back of your TV to determine which the wall, use the shorter screws (a).
Página 7
1.3 Attach TV Brackets Ensure that your TV brackets are level on the back of the TV. Standard configurations are shown. Secure TV brackets using your short screw/washer ( | Flat Back) or long screw/washer/spacer ( | Round Back / Extra Space) selection. IMPORTANT: Ensure TV brackets are securely fastened before moving on to the next step.
Página 8
STEP 2A Attach Wall Plate to Wall Wood Stud Option CAUTION: Avoid potential personal injuries and property damage! • Drywall covering the wall must not exceed 5/8 in. (16 mm) • Minimum wood stud size: common 2 x 4 in. (51 x 102 mm) nominal 11/2 x 31/2 in. (38 x 89 mm) •...
Página 9
Drill pilot holes using a 7/32 in. (5 mm) diameter drill bit. Remove wall plate template IMPORTANT: Be sure to drill into the center of the studs. IMPORTANT: Pilot holes must be drilled to a depth of 3 in. (75 mm). Install wall plate assembly using four lag bolts and four washers...
Página 10
STEP 2B Attach Wall Plate to Wall Solid Concrete or Concrete Block Option CAUTION: Avoid potential personal injuries and property damage! Concrete Installation Kit CMK1 is not included (see page 5) Contact Customer Service at • Mount the wall plate directly onto the concrete surface 888-384-1115 to have the additional hardware •...
Página 11
Remove the wall plate template and insert four anchors (Fischer UX 10 x 60R - included in the Concrete Installation Kit*). CAUTION: Be sure the anchors are seated flush with the concrete surface. Install wall plate using four lag bolts and four washers (use only the lag bolts and washers from the Concrete Installation Kit*). Tighten the lag bolts only until the washers are pulled firmly against the wall plate.
Página 12
STEP 3 Attach TV to Wall Plate HEAVY! You may need assistance with this step. IMPORTANT: You will hear an audible click when the TV bracket is securely fastened to the wall plate. CAUTION: Avoid potential personal injury or property damage! The safety latch must be locked, so the TV is securely fastened to the...
Página 13
Adjustments TILT LEVEL REMOVING THE TV Loosen the knob on the TV bracket to adjust If needed, tighten one of the screws on the top Pull down on the straps and lift the TV up the tilt of your TV. Tighten the knob when your of the TV bracket to level the TV.
58.9 kg 58.9 kg (130 lb), incluidos Sí — Este soporte NO es compatible. (130 lb) los accesorios? sanus.com Visite o llame al 888-384-1115 para encontrar un soporte compatible. ¿De qué está ¿Tabiques de yeso ¿Hormigón sólido ¿No está...
Página 15
ESPAÑOL Dimensiones Ver página 3 Piezas y elementos de sujeción suministrados Ver página 4 ADVERTENCIA: Este producto contiene piezas pequeñas que, si fuesen tragadas, podrían producir asfixia. Antes de iniciar el ensamblaje, compruebe que todas las piezas estén incluidas y en buenas condiciones. Si faltan piezas o alguna está dañada, no devuelva el artículo al distribuidor;...
Página 16
ESPAÑOL PASO 2A Fijar la placa mural a la pared - Opción para montantes de madera Ver página 8 PRECAUCIÓN: Evite posibles lesiones personales y daños materiales. • El yeso que recubre la pared no debe exceder los 16 mm (5/8 pulgada). •...
Página 17
ESPAÑOL PASO 2B Fijar la placa mural a la pared - Opción para hormigón sólido o bloques de cemento Ver página 10 PRECAUCIÓN: Evite posibles lesiones personales y daños materiales. El Kit de instalación en hormigón CMK1 no • Instale la placa mural directamente sobre la superficie de hormigón.
Página 18
ESPAÑOL Ajustes Ver página 13 AJUSTE DE LA INCLINACIÓN: Afloje la perilla AJUSTE DE LA NIVELACIÓN: Si es necesario, RETIRAR EL TELEVISOR: Jale hacia que se encuentra en la placa de sujeción del ajuste uno de los tornillos de la parte superior abajo de las correas, levante el televisor a fin de ajustar la inclinación de su de la placa de sujeción del televisor para nivelar...