Humanscale M10 Instrucciones De Montaje página 6

Attach Vesa Bracket To Monitor
1
Separate the VESA cover from the VESA bracket.
2
Position the VESA Bracket over the mounting holes
on the back of monitor with the D-shaped cutouts in
a vertical orientation. Attach using the 4 VESA screws
provided.
3
Snap the VESA cover back in place.
The VESA Bracket features 75mm and 100mm hole
patterns.
If you need to offset the Bracket from the monitor use the
provided
Extended VESA screws and Plastic Spacers. You may also
use the screws that came with your monitor.
Attach Monitor To Arm
1
Hold the monitor angled back and lower it onto the arm. Fit the hook at the top of the
arm into the corresponding cutout in the VESA Bracket.
2
Tilt the monitor back upright until the Quick Release Tab (B) on the arm snaps into position.
3
To remove the monitor, lift the Quick Release Tab and pull the bottom of the monitor away
from the arm, then lift free of the hook.
Large/curved monitors require adjusting the tension screw (A)
Clockwise until the monitor holds in position. (approx. 35 in-lbs.)
②
6
①
A
B