Cable Management - Humanscale M10 Instrucciones De Montaje

Cable Management

1
If using multiple monitors, first route the
cables through the plastic cable clips on the
front of the crossbar. If using a single monitor,
skip to step 2.
2
Route power and monitor cables through the
flexible cable clips on the M10's upper link
(B).
NOTE: Leave enough slack in the cables to allow
arms to rotate without difficulty.
3
Slide the plastic cover (C) on the lower link
upward to remove.
4
Using the two cutouts (D) as guides, run the
cables over the lower link cover.
5
Lift the cover and cables up to the lower link,
making sure that the cover sits flush with the
surface of the arm.
6
Slide the cover down the arm to lock in place,
then gently pull the cables through the arm to
remove excess slack.
CAUTION: Don't insert extension cords. Don't
insert any cord connecting one workstation to
another.
8
①
②
③
④
⑤
⑥
A
B
C
D