Tabla de contenido
Publicidad
DR-L700
A
INPUT jacks
Connect the component with RCA pin cables.
Make sure to connect :
white plug q white jack (L)
red plug q red jack (R)
black plug q black jack
B
LINK jack
If you have TEAC DR-L700, connect the LINK jacks
with the LINK cable (provided with A-L700P).
When the LINK jacks are connected, you can
switch ON/standby the power of both DR-L700 and
A-L700P by pressing the STANDBY/ON button of
DR-L700. Always leave the POWER switch of A-
L700P in the ON position.
C
AC Power Cord
When all the connection has been finished, plug
the AC power cord into an AC wall socket.
8
A-L700P
D
E
B
WHITE
RED
BLACK
Connection
D
PRESET VOLUME
Turn these knobs to adjust the volume of each
speaker.
When DR-L700 is connected, turn these knobs
clockwise so that the preset volume becomes
maximum.
E
LINK SELECTOR
Select SYSTEM when the LINK jack is connected
to DR-L700. If not, select SINGLE.
< When the LINK jack is connected to DR-L700 and
the LINK SELECTOR is set to SYSTEM, you can
switch ON/standby the power of both DR-L700 and
A-L700P by pressing the STANDBY/ON button of
DR-L700. Always leave the POWER switch of A-
L700P in the ON position.
ENGLISH
A
C
Publicidad
Tabla de contenido
