Initial Start-Up; Assembling/Dismantling The Two-Piece Blow Tube; Assembling/Dismantling The Two-Piece Suction Tube - Grizzly ELS 3027 E Traducción Del Manual De Instrucciones Original

• After they have been joined to-
gether, the blower tubes cannot
be taken apart again!

Initial start-up

Before operating the equipment, you must
- install the blower or suction pipes,
- install the collection bag for suctioning
leaves,
- install the protective cover (suction in-
take) for blowing leaves.
Caution, Risk of Injury! During
the assembly or disassembly of
the blower pipe, suction pipe,
protective cover or collection
bag, the engine must be turned
off and all moving parts must
have come to a standstill.
Always disconnect the plug
from the mains socket before
working.
Assembling/dismantling the
two-piece blow tube
Never use the leaf blower with
only one blower tube section
attached. There is a risk of per-
sonal injury!
1. Assemble the two-piece blow
tube (9) as illustrated. The parts
can be felt to lock into place.
During assembly, make sure
that the groove on the upper
section of the blower tube is in-
serted into the recess provided
on the lower section of the
blower tube.
2. Now push the blow tube (9) on
to the blowing aperture of the
motor housing (1) as far as the
locking device (8).
3. Place the protective cover of
the suction opening (7) on the
underside of the motor housing.
Turn the protective cover clock-
wise as far as it will go.
4. Attach the protective cover by
tightening the screw with star
grip (19) in the holder.
The screw with star grip has to
be tightened as far as it will go
by hand, as otherwise the leaf
blower cannot be started later.
5. Dismantle the blow tube (9) by
releasing the lock (8) and pull-
ing off the blow tube forwards.
Assembling/dismantling the
two-piece suction tube
Never use the leaf vacuum with
only one suction tube section
attached. There is a risk of per-
sonal injury!
After the two-part suction tube
has been assembled, it must
not be divided up again into two
parts!
1. Remove the protective cover of
the suction opening by unscrew-
ing the screw with star grip (19)
and turning the protective cover
anti-clockwise and removing it.
2. Assemble the two suction tubes
(17) as illustrated. The parts can
be felt to lock into place.
During assembly, make sure
GB
73