PEERLESS SA740P Manual Del Usuario página 8

Adjust tension knob on side of mount shown in figure
3
3 to desired tension to balance your screen size and
weight.
Push or pull from top or bottom of screen to adjust
tilt as shown. The tilt can be adjusted to a maximum
of 15° forward or 5° backward.
CAUTION
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 40 in. • lb (4.5 N.M.) maximum torque.
CAUTION
• Be careful not to pinch fingers when opening and
closing mount from the wall.
Note: Make sure cords have enough slack to allow full movement of the arm.
4
Route cords inside arm slots of wall mount (A) as shown in figure 4.1. Optional: Run power cord through one side of
mount and signal cable(s) through other side in order to avoid interference with the signal.
Lock cords into place by sliding cord covers (I) onto mount as shown in figure 4.2. Screen may have to be moved for
better access for sliding on the cord covers.
fig. 4.1
A
8 of 27
TENSION KNOB
fig. 3
I
fig. 4.2
ISSUED: 05-18-05 SHEET #: 095-9234-4 08-23-05