Assembly; Installation - Gardena TCS 720/20 Instrucciones De Empleo

2. ASSEMBLY

2 3 1
To assemble the telescopic
handle:
6
ß M
4
To assemble the shoulder
strap:
7
8

3. INSTALLATION

Initial Operation:
2 3 1
6
All manuals and user guides at all-guides.com
The Pruner, chain, bar, protective cover complete with Allen key and
the operation instructions are included in the scope of delivery.
DANGER! Risk of physical injury!
Cut injury when the unit starts accidentally.
v Before you assemble the unit, make sure that the mains
cable is disconnected and the protective cover
over the bar
5
1. Slide the telescopic pipe
the stop position. Ensure that the two markings
other.
2. Tighten the grey nut
CAUTION!
The supplied shoulder strap must be used.
1. Widen the belt clip
screw .
8
2. Engage the shoulder strap clasp
3. Adjust the shoulder strap to the desired length by using the
quick strap fastener.
9
DANGER! Risk of physical injury!
Cut injury when the unit starts accidentally.
v Before you initially operate the unit, make sure that the
mains cable is disconnected and the protective cover
is slid over the bar
and the snap fit is closed.
2 3
6
ß M
into the motor unit
4
.
6
and fasten it onto the beam using the
7
to the belt clip
9
and the snap fit
2
is slid
1
4
until you reach
5
face each
ß M
.
7
1
is closed.
3