Adjusting The Table Insert - Bosch 4100 Instrucciones De Funcionamiento

Table Pointer Adjustment
If an adjustment to the table pointer is necessary, loosen pointer
adjustment screw 1, adjust pointer 2 and tighten screw 1 (Fig.
25).
The table pointer should always be adjusted relative to fence
pointer.
1. Adjust fence pointer to (zero) - see "Rip Fence Pointer
Adjustment".
2. Slide fence to the right until it hits the stop plate on front rail
and lock fence in place.
3. Look at fence pointer and note measurement on lower scale
(at or near 13.5").
4. Adjust the table pointer 2 to the same reading on upper scale
as that shown on the fence pointer. Both pointers must agree
when fence is at this position.
Example: If fence pointer is at 13-9/16", then table pointer
should also be set at 13-9/16".

Adjusting The Table Insert

The table insert includes four (4) adjustment screws 3 to set the
height (Fig. 26). Place the insert onto the table. Place a straight
edge (such as the metal ruler from a combination square) across
the table top and insert top – the surfaces should be at the same
level. If adjustment is necessary, use a small slotted screwdriver
to rotate each set screw.
FIG. 25
FIG. 26
3
40.
2
1
3