Adjusting The Table Insert - Bosch GTS1031 Instrucciones De Funcionarniento Y Segurida

Ocultar thumbs Ver también para GTS1031:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

NOTE:
The spacing
instructions
are based on
using the standard
kerf blade supplied with your
GTS1031.
If a smaller or larger kerf blade is used,
adjust the spacer. For instance,
if the kerf of the
replacement
blade is larger, use 6 or more thick-
nesses of paper and if it is smaller, use 4 or less
thicknesses.
Depending
on the type of paper
used as a spacer, you may need to modify
the
number of folds for proper alignment.
7. Insert folded paper 5 between
Riving Knife I and
Fence 3.
A. Hold Riving Knife and paper firmly against
Fence (Fig. 27 & 28).
1
8
8
8
2
5
---1
_¸-
_T
3
D. Slowly turn the Set Screw 7 while watching
the
Riving Knife tilt until it is in line with the blade.
E. Recheck squareness
of riving knife to table by
sliding fence against blade. Readjust if neces-
sary.
8. After completing
adjustments:
A. Lightly tighten hex nut 6 (hold set screw posi-
tion with screwdriver
while tightening
nut).
B. Fully
tighten
Clamp
Screws
8 with
Allen
wrench. Then fully tighten the hex nut.
NOTE: Check that the riving knife stays in line with
blade when the blade is tilted at any angle. Replace
the Barrier Guard Assembly
and Anti-Kickback
De-
vice before making cuts.
ADJUSTING
THE TABLE
INSERT
The GTS1031
table insert slot includes four (4) ad-
justment
screws 9 to set the height (Fig. 29). Place
the insert 10 onto the table 11. Place a straight edge
(such as the metal ruler from a combination
square)
across the table top and insert top - the surfaces
should be at the same level. If adjustment
is neces-
sap!, use the included 2 mm "L wrench" (packed with
the table insert) to rotate each set screw up or down.
11
B. Lightly tighten the clamp screws 8.
C. Remove
the paper - Slide fence away from
blade.
-21-

Publicidad

Tabla de contenido
loading

Tabla de contenido