General Safety Instructions; Safety Instructions For All Operations - Festool DSG-AG 125 Manual De Instrucciones

Dia grinding system DSG-AG 125
1 Technical data
Exhaust Cover
Exhaust hose
Weight
Angular grinder
Voltage
Frequency
Input
Idle revolutions
Circumferential speed
Grinding wheel
Grinding spindle thread
Limits to interaction current
Revolutions pre-setting
Constant electronics
Heat protection
Weight
Protection level
2 Symbols
Double insulation
Warning of general danger
Risk of electric shock
Use protective goggles!
Wear ear protection!
Read the instructions
Not to be included in municipal refuse

Advice or tip
3 Control elements
[1-1] Exhaust Cover
[1-2] Bar guide
[1-3] Threading for clamping and additional
handle
[1-4] Revolutions pre-setting
[1-5] Power cable
GB
DCG-AG 125
27/36 mm
0.38 kg
AG 125-14 DE
220 – 240 V~
50 / 60 Hz
1400 W
3500 – 11000 min
80 m/s
max. 125 mm
[1-6] Angular grinder
[1-7] On/off switch
[1-8] Additional handle
[1-9] Spindle locking plunger
[1-10] Brush ring
[1-11] Sliding front segment
[1-12] Lever
Accessories that are illustrated or described here
are not always included in the scope of delivery.
The specifi ed illustrations can be found at the be-
ginning of the operating instructions.
4 Intended use
–1
The Dia grinding system consists of an angle
grinder and extraction hood, and is designed for
dust-free grinding of mineral materials, smooth-
M 14
ing unevenness, removing paint, concrete, adhe-
•
sive and plaster as well as preparing surfaces for
•
new coatings.
•
The user proper is responsible for improper us-
•
age.
2,3 kg
II /
5 Notes on Safety Prevention
5.1

General safety instructions

WARNING! Read all safety warnings and
all instructions. Failure to follow the warn-
ings and instructions may result in electric
shock, fi re and/or serious injury.
Save all warnings and instructions for future
reference.
The term „power tool" in the warnings refers to
your mains-operated (corded) power tool or bat-
tery-operated (cordless) power tool.
5.2

Safety instructions for all operations

General safety instructions for grinding:
a) This power tool is intended to function as a
grinder. Read all safety warnings, instruc-
tions, illustrations and specifi cations provided
with this power tool. Failure to follow all in-
structions listed below may result in electric
shock, fi re and/or serious injury.
b) Operations such as sanding, wire brushing,
polishing or cutting-off are not recommended
to be performed with this power tool. Opera-
tions for which the power tool was not designed
may create a hazard and cause personal injury.
c) Do not use accessories which are not specifi -
cally designed and recommended by the tool
manufacturer. Just because the accessory can
be attached to your power tool, it does not as-
sure safe operation.
13