Dust Extraction; Switching On/Off - Festool DSG-AG 125 Manual De Instrucciones

7 Safety elements assembly
WARNING
Risk of accident, electric shock
 Always pull the plug out of the socket before
performing any type of work on the machine.
CAUTION
Always use the additional handle to guarantee
a safe, non-tiring working posture.
7.1 Exhaust cover
Assembly [2]
Removal [2 a]
7.2 Brush ring
Assembly [3]
Removal [3 a]
7.3 Additional holder
Special construction "VIBRASTOP" regulates the
vibrations with additional holder [1-8].

7.4 Dust extraction

WARNING
Dust hazard
 Always work with a dust extractor.
To ensure suction, put the hose of a Festool vacuum
cleaner class M or H into the suction adapter [1-2].
Warning: Always work with the suction connect-
ed. Use exclusively antistatic vacuum cleaners to
prevent discharges of static electricity in dusty
environments.
8 Fastening the grinding wheel
WARNING
Do not use quick-change nuts for clamping the
disc!
WARNING
Only use diamond grinding discs recommended
by the manufacturer and the prescribed fl ang-
es included with the cover and the grinder [4].
16
- For reasons of safety, always use original Fes-
tool sanding discs!
- If the permissible revolution speed is given on
the disc, it must not be lower than the highest
no-load speed of the grinder.
- Discs with a permissible peripheral speed of
80 m/s and higher may be used.
- Test new grinding discs by letting them run for
about one minute with no load.
- Unbalanced or vibrating discs should not be
used and should be discarded.
- Protect grinding discs from shock, impact and
lubricants.
8.1 Assembly with standard fastening nut
 Clean the fl ange [4-2] and fastening fl ange [4-
3] and grinding wheel fastening areas.
 Mount the fl ange [4-2] with shoulder out to
grinding wheel [4-1].
 Mount grinding wheel. Flange shoulder must
fi t the grinding wheel aperture.
9 Activation
WARNING
Risk of accident if the machine is operated us-
ing unauthorised voltages or frequencies.
 The mains voltage and the frequency of the
power source must correspond with the spec-
ifi cations on the machine's name plate.
 In North America, only Festool machines with
the voltage specifi cations 120 V/60 Hz may
be used.
9.1 Switching on – off
Switching on
 Slide the on/off switch [1-7] forwards.
 Continuous operation: pressing the front part
of the switch at the same time locks the on/
off switch.
The electric power tool starts.
Only make contact with the material once the
machine has reached operating speed.
Switching off
 Lift the electric power tool from the processed
material.
 Release the on/off switch [1-7].
 During continuous operation: press on the
rear part of the on/off switch [1-7].