Tabla De Contenido; Symbols; Technical Data; Intended Use - Festool LEX 2 185/7 Manual De Instrucciones

Contents
Symbols ................................................ 2
Technical data ...................................... 2
Intended use......................................... 2
Safety instructions ............................... 2
Compressed-air supply and commis-
sioning .................................................. 5
Settings................................................. 7
Working with the machine ................... 8
Service and maintenance..................... 8
Accessories .......................................... 9
Environment ......................................... 9
Warranty ............................................... 9

Symbols

Warning of general danger
Manual, read the instructions
Wear ear protection.
Wear protective goggles.
Wear a dust mask.
Do not throw in the household waste.
n no-load speed
0
.../min revolutions per minute
-1
min

General safety instructions

General safety regulations
Warning! Before setting up, using, repairing
and servicing this compressed air tool or re-
placing accessory parts, you must have read and
understood all safety instructions and informa-
2
min minutes
l liter
bar bars
Compressed air eccentric
sander
Sanding pad diameter
Drive
Operating pressure (flow
pressure)
Speed
Working strokes
Sanding stroke
Air consumption at nominal
load
Weight
The compressed air eccentric sanders are suitable
for sanding wood, plastic, metal, stone, compos-
ites, acrylic-based mineral materials, paint/clear
coats, fillers and similar materials.
Materials containing asbestos must not be pro-
cessed.
Only use with Festool hose system IAS 2 or IAS 3
and Festool sanding pads!
The user is liable for improper or non-in-
tended use.
Safety instructions
tion. Ignoring warning notes and instructions may
result in serious injuries.
- Only trained and qualified persons are permitted
to set up, adjust and operate this compressed air
tool. Persons without the relevant qualifications
and training are more likely to cause accidents.
- This compressed air tool may not be modified.
Modifications may reduce the effectiveness of

Technical data

LEX 2 185/7
185 mm
Compressed-air
vane motor
6 bar
6500 - 8000 rpm
13000 - 16000 rpm
7 mm
390 l/min
1.4 kg

Intended use