Haier HSU09XHK-G Manual Del Usuario página 6

Operation
Timer On/Off On-Off Operation
1.After unit starts, select your desired operation mode.
2.Press TIMER button to change TIMER mode. Every
time the button is pressed, display changes as follows:
Remote controller:
0.5h 0.5h
TIMER ON TIMER OFF TIMER ON-OFF
Then select your desired TIMER mode (TIMER ON or
TIMER OFF or TIMER ON-OFF). "
3.Press / button to set time.
Press the button for each time, setting time in the first
12 hours increased by 0.5 hour every time, after 12
hours,increased by 1 hour every time.
Press the button for each time, settiing time in the first
12 hours decreased by 0.5 hour every time, after 12
hours,decreased by 1 hour every time.
It can be adjusted within 24 hours.
4.Confirm timer setting
After adjusting the time,press
the time the ON or OFF button will not flash any more.
5.Cancel timer setting
Press the timer button until the time display eliminated.
Hints:
After replacing batteries or a power failure happens, time
setting should be reset.
According to the Time setting sequence of TIMER ON or
TIMER OFF, either Start-Stop or Stop-Start can be achieved.
4
BLANK
0.5h 0.5h
TIMER OFF-ON
"or " "will flash.
button and confirm
Healthy airflow Operation
1.Press to starting
Setting for comfortable conditions.
2.The setting of healthy airflow function
Press button to enter additional options,Press this
button continuously, the louvers location will cycle between
in the following three locations, to choose the swing location
what you needed,and then press
Healthy
airflow
upwarder
3.To cancel of the healthy airflow function
Press button to enter additional options,Press this
button continuously, the louvers location will cycle between
the three locations again,and then press
cancel.
Notice: Do not direct the horizontal by hand. This may
cause the louver to run incorrectly and not match the
display. If the louver is not running correctly, stop the unit
for a minute and then restart and adjust remote controller.
Note:
1.After setting the healthy airflow function, the position
louver is fixed.
2.In heating, it is better to select the
3.In cooling, it is better to select the
4.In cooling and dry, using the air conditioner for a long
time under the high air humidity, condensate water may
occur at the grille .
button to confirm.
Healthy
Present
airflow
position
downwarder
button to
mode.
mode.