Power smart DB7624E Manual De Instrucciones página 9

• Check bolts and screws for proper tightness (EVERYTIME before & after use) as engine vibration
could cause hardware to loosen...consider using a Loc-Tite product to keep hardware secure.
This process will keep the machine in safe working condition. Also, visually inspect machine for any
damage.
• Verify that the auger gearbox, located between your right and left auger blades, has substantial
lubricant in the casing.
The gearbox fill and drain plugs (bolts) are the only "vertical" plugs (bolts) on the gearbox assembly
when viewed in the standing position. The top plug (bolt) is used for filling...the bottom plug (bolt) is
for draining. Simply remove the top plug (bolt) for verification of lubricant, as it should be inside. To
drain, simply remove bottom plug (bolt).
• Do not change the engine governor setting or overspeed the engine. The governor controls the
maximum safe operating speed of the engine.
• Snow thrower auger belts, shave plates, shear pins and skid shoes are subject to wear and
damage, therefore it is expected that the owner assume personal responsibility for the
maintenance (removal & installation) of these items.
• For your safety protection, frequently check all components and replace with original equipment
manufacturers (OEM) parts only. Use of parts which do not meet the original equipment
specifications may lead to improper performance and compromise safety.
• Check (drive & auger) control lever (handles) and cables periodically to verify they engage and
disengage properly and adjust, if necessary. Refer to the adjustment section in this operator's manual
for instructions.
• Maintain or replace safety and instruction labels, as necessary.
• Observe proper disposal laws and regulations for gas, oil, etc. to protect the environment.
• Prior to storing, run machine a few minutes to clear snow from machine and prevent freeze up of
auger impeller and completely wipe down unit, while inspecting for frozen components.
• Never store the machine or fuel container inside where there is an open flame, spark or pilot light
such as water heater, furnace, clothes dryer etc.
• Always refer to the operator's manual for proper instructions on off-season storage. A YouTube video
is available, which illustrates this process:
https://www.youtube.com/watch?v=X4KYcFEfeY4
• Check fuel line, tank, cap and fittings frequently for cracks or leaks. Replace if necessary.
• Do not crank engine with spark plug removed.
• Have the machine inspected annually by an authorized service dealer to ensure that all mechanical
and safety systems are working properly and have not worn excessively*. Failure to do so can result
in accidents, injuries or death.
*Please note that an annual inspection is not covered within the warranty program...only
REPAIR service.
DO NOT MODIFY THE ENGINE
To avoid serious injury or death, do not modify engine in any way. Tampering with the governor setting
can lead to a runaway engine and cause it to operate at unsafe speeds. Never tamper with factory
setting of engine governor.
9