Waeco CA-45 Instrucciones De Uso página 23

_CA-45.book Seite 23 Montag, 3. Mai 2004 9:22 09
CA-45, CAB-45
➤ Open the lid of the control panel (2 1, page 3) by pressing down on it.
Press down on the lid again to close it.
The further you turn the corresponding control towards "MAX",
the lower the refrigerating temperature.
Ensure that the objects placed in the cooler are suitable for
cooling to the selected temperature.
Ensure that food or liquids in glass containers are not excessively
refrigerated. Liquids expand when they freeze and can thus destroy
the glass containers.
Connecting to 220 V – 240 V
Check that the voltage specification on the type plate corresponds
to that of the energy supply.
➤ Plug the earthed plug into a properly installed safety plug socket.
➤ Set the thermostat control (2 2, page 3) to "MAX".
➤ Wait until the temperature in the cooler has dropped.
➤ Set the thermostat control (2 2, page 3) to the desired temperature range.
➤ To switch off the cooler, set the thermostat control (2 2, page 3) to "0"
and pull out the plug.
Connecting to 12 V DC
You cannot set the temperature with the thermostat control
during battery operation. The device is simply switched on
and starts cooling.
Disconnect the cooler from the battery when the engine is not
running as otherwise the battery will be completely run down.
➤ Make sure that the cable from the battery to the cooler is protected by
a fuse (max. 15 A).
All manuals and user guides at all-guides.com
Operating the cooler
23