Safety Notes; Important Notes; Multi-Protocol Operation - Trix 22966 Manual Del Usuario

Safety Notes

• This locomotive is only to be used with the operating
system it is designed for.
• Analog max. 15 volts DC, digital max. 22 volts AC.
• This locomotive must never be supplied with power from
more than one power pack.
• Please make note of the safety notes in the instructions
for your operating system.
• The feeder track must be equipped to prevent inter-
ference with radio and television reception, when the
locomotive is to be run in conventional operation. The
611 655 interference suppression set is to be used for this
purpose. The interference suppression set is not suitable
for digital operation.
• WARNING! Sharp edges and points required for operation.
• Do not expose the model to direct sunlight, extreme
changes in temperature, or high humidity.
• The LEDs in this item correspond to Laser Class 1 accor-
ding to Standard EN 60825-1.
General Note to Avoid Electromagnetic Interference: A
permanent, flawless wheel-rail contact is required in order
to guarantee operation for which a model is designed. Do
not make any changes to current-conducting parts.

Important Notes

• The operating instructions and the packaging are a com-
ponent part of the product and must therefore be kept as
well as transferred along with the product to others.
• Please see your authorized Trix dealer for repairs or
spare parts.
All manuals and user guides at all-guides.com
• The warranty card included with this product specifies
• Disposing: www.maerklin.com/en/imprint.html
• The full range of functions is only available under Trix
• Built-in headlights that change over with the direction of
• Minimum radius for operation is 360 mm/14-3/16".

Multi-Protocol Operation

Analog Operation
This decoder can also be operated on analog layouts or ar-
eas of track that are analog. The decoder recognizes alter-
nating current (DC) and automatically adapts to the analog
track voltage. All functions that were set under mfx or DCC
for analog operation are active (see Digital Operation).
Digital Operation
The decoders are multi-protocol decoders. These decoders
can be used under the following digital protocols: mfx or DCC.
The digital protocol with the most possibilities is the highest
order digital protocol. The sequence of digital protocols in
descending order is:
Note: Please note that not all functions are possible in all
digital protocols. Several settings for functions, which are
supposed to be active in analog operation, can be done
under mfx and DCC.
the warranty conditions.
Systems and under DCC and mfx.
travel. They can be turned on and off in digital operation.
Priority 1: mfx
Priority 2: DCC
Priority 3: DC
9