Carrier 42ADF025 Manual Del Usuario página 15

42ADF025, 42ADF035
Use of the Remote Control
Sleep timer procedure "night"
(button M)
Press this button to set the SLEEP timer with remote control on.
The icon will apear on the display.
This prodedure permits setting the remaining unit operating time.
1.
"1 :hr" will be displayed together with the
icon.
2.
Press button
The display will show the following
settings in sequence: 1 hr, 2 hr, 3 hr, 4
hr, 5 hr, 6 hr, 7 hr, 8 hr and 9:hr.
3.
Once the remaining operating hours
have been selected with either button
or , again press button
4.
When the SLEEP timer is set, the
unit will control the set temperature to
avoid ovecooling or overheating during
operation. The set temperature will
change as follows:
SET TEMP.
SET TIME
(Cooling only or dehumidification)
SET TEMP.
SET TIME
(Heating)
All manuals and user guides at all-guides.com
Current time adjusting
buttons (buttons N and O)
Press current time adjusting button
Press reset button "O" with a sharp object if the remote control
is not operating properly or after replacing the batteries.
Setting current time
(temperature increase).
1.
2.
to confirm.
3.
4.
TIME (MIN.)
TIME (MIN.)
With the remote control ON or OFF,
keep pressing button for at least
5 seconds.
The current hour figure flashes. Press
either button or to set the current
hour. Press button to move to minutes
and set them.
For this setting always use either button
or .
Once the current time is set, press
button to confirm it.
GB
E N G L I S H
and reset
to adjust the current time.
(button N)
PM
13