Use Of The Remote Control; Temperature Setting - Carrier 42ADF025 Manual Del Usuario

42ADF025, 42ADF035

Use of the Remote Control

Start / Stop
(button B)
When the air conditioner is not in operation, the remote control
readout will display the time of day only (in case other symbols
are lit, turn control off by pressing button
Press button to start the air conditioner.
All selected and memorized functions will light up and appear;
the unit will operate according to the functions selected.
Press button to stop the air conditioner.
All indicators on the unit will go out, and the control will display
only the current time.
If the unit does not stop, turn the control on (by pressing button
) and repeat the operation.
If button (air conditioner starting) is pressed too soon after
a stop, the compressor will not start for 3/5 minutes due to the
inherent protection against frequent compressor cycling.
The unit will only emit a "beep", when the signals are received
correctly.
Selection of the operating mode
(button A)
With this button the operating mode of the air conditioner can
be selected.
By repeatedly pressing this button the available modes will be
selected in sequence.
The choosen mode is shown as follows, while the unit will
acknowledge signal receipt with a confirming beep.
Indicated Symbol
Ventilation (fan only).
Heating.
Automatic.
Cooling with dehumidification.
Dehumidification only.

Temperature setting

UP
(button C)
DOWN
(button D)
Pressing the UP and DOWN
decrease the temperature from the previously set value.
The unit will confirm signal receipt with a beep, and the value of
the set temperature on the display will change accordingly.
The temperature can be set between 17°C (63°F) and 32°C
(90°C) at 1 degree intervals.
In cooling mode, if the temperature selected is higher than the
room temperature the unit will not start; the same applies for
the heating mode, if the selected temperature is lower than the
room temperature.
10
All manuals and user guides at all-guides.com
).
buttons will increase or
Selecting direction of air flow
louvre (button H)
The air flow direction can be adjusted to optimize air distribution
in the room.
Press button repeatedly to choose one of the following
louvre positions:
Symbol on display
Air direction will be set automatically. "'l i
will be set to the preset position according to the
operation mode.
6 positions can be chosen.
The louvre can be set to one of 6 different
air fow directions.
The louvre will continuously swing up and down.
"Swing" always assures optimal even air distribution.
Louvre