NEC L3H Manual Del Usuario página 33

All manuals and user guides at all-guides.com
Use the scroll bar to move up and down the list in order to view the software
that cannot be seen in the list.
Once you have made your selection, click on OK. You will be prompted for
confirmation. Click on Yes to allow Smart Restore to start reinstalling/
uninstalling the software, or on No if you wish to abort the procedure.
Depending on your computer model and on the software you selected, you
may be asked during the reinstallation process to insert a Master CD into its
drive.
Once all the software has been reinstalled, you will be prompted to restart your
computer. Click on OK to restart, or on Cancel to continue without restarting.
It is not necessary to restart at that precise moment, especially if you want to
restore other software or hardware, but we advise you to restart before starting
any of the software you just reinstalled. The Smart Restore main sreen will re-
appear. Click on Cancel to close the Smart Restore program.
Resetting Y Y Y Y Y our Hard Resetting Resetting our Hard our Hard our Hardware Conf ware Conf ware Configuration (Wind ware Conf
Resetting Resetting our Hard ware Conf
If you encounter some problems with your original computer hardware, you
may want to restore your hardware configuration so that it is exactly as it was
when your computer left the factory.
Click on the Hardware tab to make it active. To select the component you wish
to restore, click on its name. Once it is selected there is a green check mark in
front of it. Click on the component's name again, or on its check mark to deselect
the hardware. You may select as many components as you wish, Smart Restore
will reinstall them one after another without any further intervention from you.
Click on Full Install if you wish to reinstall all the hardware. Click on any
unwanted component to deselect it. Once they are all checked, you may
click on Deselect All if you changed your mind or made a mistake.
Once your selection is made, click on OK. You will then be prompted for
confirmation; click on Yes to start restoring the hardware, or on No if you do
not wish to pursue the procedure. Depending on your computer model and
on the hardware you selected, you may be asked during the reinstallation
process to insert a Product Recovery CD into its drive.
Once all the hardware has been restored, you will be prompted to restart
your computer; please do so by clicking on OK, it will ensure that your
hardware is correctly restored.
Copyright©2001 NEC Computers International BV
Smart Restore Smart Restore Smart Restore
Smart Restore Smart Restore
iguration (Wind iguration (Windo o o o o ws 98 only) iguration (Wind ws 98 only) ws 98 only) ws 98 only)
iguration (Wind ws 98 only)
33