Kreg Jig K4 Manual Del Propietário página 8

Repair Applications
7
For repair applications, remove the drill guide from the drill
guide socket and clamp it directly to the workpiece.
For ½" (13mm)-thick material, align the bottom of the drill
guide with the edge or end of the part to be drilled. For thicker
stock, attach one or more spacer blocks to the drill guide.
Each spacer block accommodates an additional ¼" (6mm)
in material thickness. For example, ¾" (19mm)-thick material
requires one spacer block, 1" (25mm)-thick material requires
two blocks, and 1¼" (32mm) thick material requires three
blocks. One spacer block is included with your Kreg Jig .
®
Additional blocks are available.
When using the drill guide separately in a repair application,
remember to set the drill-bit stop collar, and firmly secure the
drill guide to the workpiece with a bar clamp, C-clamp, or Kreg
face clamp. In situations where using a clamp is not possible,
you may screw the drill guide directly to the workpiece, as
shown.
Kreg Jig K4 Master System Additional Features
®
Vacuum Port
This chip-collection attachment snaps into place on the
back of the drill guide socket. The port accepts a standard
1¼" (32mm) vacuum hose. In addition to helping keep your
work area clean, efficient chip removal speeds drilling time
and reduces heat build-up, extending the life of your drill bit.
Workpiece Support Stop
The support stop can be screwed directly to your work
surface. To support large panels, pivot the stop arm down
and rest the panel on the stop base. For repetitive pocket-
hole drilling operations, pivot the stop arm up and adjust
the nylon machine screw to the desired position. The nut
and bolt work together to provide easy adjustment and the
knurled nut locks the bolt in position.
Face Clamp
To keep joints perfectly aligned when driving pocket screws,
clamp the workpieces to a flat surface, centering the clamp
pad over the joint line. Adjust the clamp to apply enough
pressure to keep the workpieces flush and stable but not so
tight that clamping and unclamping are difficult.
800-447-8638