Connecting Water Supply - Amana SBDE520TW Instrucciones De Instalación

™ ™ ™ ™ ™
8. Ice 'N Water Dispensing Models
Loosen screw from water tube clamp. Loosen
6.4 mm plastic water tube union nut by hand.
Pull water tube away from union nut and through
tube clamp. Unplug top hinge wire connectors.
WARNING
To avoid electrical shock which can
cause severe personal injury or death,
green/yellow earthing wire must remain
attached to hinge. Do not dissassemble.
9. Remove top Deepfreeze
screws.
10. Remove tape from Deepfreeze
holding door securely.
11. Remove Deepfreeze
opening. This will free Deepfreeze
bottom hinge pin.
™ ™ ™ ™ ™
Ice 'N Water Dispensing Models
Slide plastic water tube through slot in bottom
door hinge as door is raised.
12. Remove bottom hinge by removing screws.
13. Install doors by reversing steps 1-12.
All manuals and user guides at all-guides.com
®
hinge by removing
®
door while
®
door by lifting while
®
door from

Connecting Water Supply

Materials Required
2.5 m of 6.4 mm flexible copper tubing
Important
Before installing ice maker, contact a plumber to
connect copper tubing to household plumbing in
compliance with local codes and ordinances.
Warranty will be void if installation is improper or a
self-piercing valve is used.
Procedure
Caution
To avoid property damage, observe the
following:
1. Check for water leaks prior to
returning refrigerator to normal
location.
2. Start tubing nuts by hand to avoid
cross threading. Finish tightening
nuts using an adjustable wrench.
Do not overtighten.
3. Check carefully for water leaks 24
hours after installation.
1. Turn off water supply to refrigerator.
2. Seal open end of copper tubing with tape.
3. Route copper tubing up to refrigerator. Copper
tubing route must be above 2°C to prevent water
line from freezing.
4. Remove masking tape from end of copper
tubing.
5. Put other end of copper tubing into bucket. Turn
on water supply to refrigerator. Water will be
under considerable pressure. Allow water to run
through copper tubing. Turn off water supply to
refrigerator when flushing is complete.
6. Remove and retain lower cover by removing
screws.
4