Photocell Settings - Nice M-BOARD Instrucciones De Seguridad Y Advertencias Para Instalación, Uso Y Garantía

To set the Operation Mode set the PROG switch to the position as
shown in the figure below, and press the LEARN button according to
the desired setting:
LED blinks 1 time
LED blinks 2 times
LED blinks 3 times
Once selected, return the PROG switch to the OFF position (all
down) for the control panel to save the configuration.

18 - PHOTOCELL SETTINGS

In this mode it is possible to configure the photocell operation mode:
NA: Normal operation (Normally Open);
Photocell Closes: In this mode, after leaving the front of the photo-
cell the gate closes automatically after counting the set time.
Count Queue: In this mode, upon receiving a pulse from (Pushbut-
ton Opens), the switch adds 1 to the counter, and will only close the
gate after passing in front of the photocell.
Example: If 3 pulses are received at the pushbutton (Opens), it will
be necessary to perform 3 triggers on the photocell to close the gate.
To configure photocell operation, set the PROG switch to the position
as shown in the figure below, and press the LEARN button according
to the desired setting:
80
ON
1 2 3 4 5 6
APFP (open, stop, close, stop)*
AF (open, close)
APF (open, stop, close)
ON
1 2 3 4 5 6
ENGLISH
DP
7 8
DP
7 8