Once selected, return the PROG switch to the OFF position (all
down) for the control panel to save the configuration.
23 - GATE TYPE
In this mode it is possible to configure in which gate the control panel
is installed.To configure the type of gate installed set the PROG swit-
ch to the position as shown in the figure below, and press the LEARN
button according to the gate type:
Once selected, return the PROG switch to the OFF position (all
down) for the control panel to save the configuration.
24 - PARTIAL OPENING
In this mode it is possible to set the gate opening percentage when
the remote control configured as partial opening is activated.
ON
1
2
LED blinks 1 time
LED blinks 2 times 30 seconds
LED blinks 3 times 60 seconds
LED blinks 4 times 90 seconds
LED blinks 5 times 120 seconds*
ON
1
2
LED blinks 1 time
LED blinks 2 times Sliding
DP
3
4
5
6
7
8
10 seconds
DP
3
4
5
6
7
8
Tipper*
ENGLISH
83