3
1
7
7
8
7
9
6
11
Scope of supply:
2
1x plastic case, left (1)
1x locking cylinder, plastic case (3)
1x plastic case, right (2)
1x locking cylinder, plastic case (3)
4x ISA collar screws M8x50 (4)
4x spacers 20x8.2x8 (5)
4
It is important to read the following notes before using the cases.
5
WHEN THE CASES ARE MOUNTED, ESPECIALLY WHEN THEY ARE LOA-
DED, GREATER SIDE WIND SUSCEPTIBILITY WILL CAUSE A CHANGE IN
VEHICLE HANDLING CHARACTERISTICS WHILE RIDING, TAKING CURVES,
AND BRAKING. EXERCISE CAUTION IN HIGH WINDS. BECAUSE OF THE
CHANGED HANDLING CHARACTERISTICS, APPROACH THE RECOM-
MENDED MAXIMUM SPEED OF 150 KM/H SLOWLY.
Always use two cases at the same time and distribute the load evenly bet-
ween the two sides.
Secure the load against slipping.
Ensure that the load never exceeds 10 kg per case.
When cleaning with a pressure cleaner, keep a distance of at least one meter
away from the cases.
Assembly
- Turn the key 45° counterclockwise.
- Swivel out the case lever (6).
6
- Remove the original screws (7) and take off back plate (8).
- Position the spacers (included) (5) on the rear fender (9).
7
- Mount the back plate with the screws M8x50 (included) (4).
-
The case lever is not engaged (6).
- Position the case (included) on the vehicle (see Figure A).
10
60312924000
60312924050
60312925000
60312924050
0035080506
60312910010
7