Maintenance / Servicing - Hozelock 4615 Manual De Instrucciones

OPERATION
- Follow the manufacturer's instructions for the
treatment agents (dosage, application method,
rinsing).
- Only prepare the quantity of agent that is
strictly necessary and for one application.
- Dosing is easy due to the graduation scale on
the reservoir. The transparent tank allows full
visibility of the liquid level.
- Preparation of the solution to be sprayed:
a) Powder product (soluble or wettable):
prepare the solution in a bucket before decanting
it into the reservoir through the filling hole.
b) Liquid-based product (to be diluted in
water): fill the tank with 1 to 2 litres of water,
pour in the dose of liquid product, then fill up
with the required quantity of water (Fig. 14).
During use
- Manually screw the filling cap on the tank after
having add water in the tank (Fig. 14).
- This sprayer is equipped with a pressure
selector. To select the pressure, you have to use
the "3S" button, placed on the right part of the
sprayer (Fig. 15).
• Press once to start your sprayer, the LED light
will turn green, the sprayer will start at speed 1
• Pressing for the second time, LED light changes
to orange, get speed 2.
• By pressing a third time, the LED light changes
to red, get speed 3.
• Pressing a fourth time, the LED light is turned
off and the sprayer will stop, leaving it on
standby to be used again when required.
- The charge status indicator is on the button 3S
(Fig. 15)
- While the light remains on with the color
corresponding to the selected speed, this
indicates that the state of the battery charge is
adequate. When the selected speed regardless
of color activates with flashing red light this
means that the battery is discharged and in
a few minutes the spray will stop working,
requiring to be recharged or replaced the battery
to keep running.
MAKE SURE TO UNPLUG THE SPRAYER FROM
THE CHARGER BEFORE OPERATION THE
SPRAYER.
- Spray by pressing the handle switch (Fig. 16).
- Adjust the jet by turning the nozzle in both
directions (Fig. 17, depending on the model.
17.b Release the trigger before rotating nozzle
to different settings. Ensure the arrow is aligned
with the number before spraying. Failure to do
so may result in leaks).
- A range of accessories are available to ensure
treatments suitable for different uses (weed
control booms, telescopic lance, weed control
cover, etc.) (Fig. 13).
See the website www.hozelock.com
After use/ Cleaning
After each use:
- Avoid risks of pollution by recovering any
unused product and its packaging.
- Wash your hands and face with clean water
after using the sprayer.
- Never store the treatment agent inside the sprayer.
- Store the sprayer in a closed location out of the
reach of children.
- It is recommended to recharge the battery
after each working day.
- Clean the handle filter, tank filter, filling filter
and the nozzle in fresh water (Fig. 18-19-20).
- The residual volume of liquid is less than 250 ml.
- Before storing and before any other use
with another treatment agent, perform a
rinsing operation, i.e. put 1 litre of water into
the reservoir for dilution, mix thoroughly
and operate the apparatus to rinse all of the
apparatus' components.
This rinsing operation must be carried out
without removing any of the accessories used
during the treatment. The rinsing mixture must
not be emptied into a sewer but must be sprayed
outside on the land that has already been
treated.
- Repeat the operation several times before the
winter period.
- If there is still some unused treatment product left,
eliminate any pressure remaining in the apparatus
by spraying with the pump off.
Recover any possible excess of product and rinse
the sprayer again as indicated above.
- Before using again, even if it is used again
immediately, with the same treatment product
or a different one, repeat the rinsing operation
3 consecutive times and check that the sprayer
works properly.

MAINTENANCE / SERVICING

- Periodically, on re-use after the winter period
and several times per season, check that the
sprayer is working properly.
- Clean the nozzle and the nozzle holder (Fig. 18)
- Clean the filters and filling filter (Fig. 19-20)
- The sprayer is equipped with a reservoir which
is resistant to UV radiation.
- For extended periods of inactivity, you should
remove the battery from the sprayer and store
at half load in a dry and stable temperature
(ideal range of 5 ° to 15 ° C), it is also advisable
to monitor the state of charge at least once
every six months and whether to proceed with
timely recharge depending on future use.
12