Ego Power+ CS1610E Manual Del Usuario página 13

PROBLEM CAUSE
◾
◾
◾
Chain saw does not cut
◾
properly.
◾
◾
◾
Chain becomes loose or
drops off the guide bar
◾
during normal use.
WARRANTY
EGO WARRANTY POLICY
Please visit the website egopowerplus.com egopowerplus.com for full terms and conditions of the EGO Warranty policy.
Insufficient chain tension.
Dull chain.
Chain installed backwards.
Worn chain.
Dry or excessively stretched chain.
Chain not in bar groove.
The chain will become loose as the
temperature of the chain increases
during normal saw operation.
Chain does not engage drive sprocket.
SOLUTION
◾
Readjust the chain tension, following
the section: "ADJUSTING THE CHAIN
TENSION".
◾
Sharpen the chain.
◾
Reinstall the saw chain, following the
section "ASSEMBLING/REPLACING THE
BAR AND CHAIN".
◾
Replace the chain, following the section:
"ASSEMBLING/REPLACING THE BAR AND
CHAIN".
◾
Check the oil level. Refill the oil tank if
necessary.
◾
Reinstall the saw chain, following the
section: "ASSEMBLING/REPLACING THE
BAR AND CHAIN".
◾
Tighten the chain tension, following
the section "ADJUSTING THE CHAIN
TENSION"
◾
Reinstall the saw chain, following the
section: "ASSEMBLING/REPLACING THE
BAR AND CHAIN".
CORDLESS CHAIN SAW — CS1610E
EN
13