Waeco EasyCool EC-1500-AC Instrucciones De Montaje Y Uso página 51

ec_1500_2000.book Seite 51 Freitag, 12. Mai 2006 4:11 16
5.2.4 Laying the supply line
– see Fig. 8 on page 5 –
Make sure there is no voltage at electrically operated components before
carrying out work on them!
➤ Connect the roof air conditioner to a power circuit which can supply
5.2.5 Laying control cables
(EC-1500-AC/DC and EC-2000-AC/DC only)
The EC-1500-AC/DC and EC-2000-AC/DC roof air conditioners are
supplied together with an inverter (refer to the "Inverter" section on
page 58) and a charging current distributor (refer to the "Charging current
distributor" section on page 62). These components are connected to the
device with control cables.
Only for AC/DC versions: For installing the charging current distributor
refer to the "Charging current distributor" section on page 62.
For installing the ECW-012VS inverter refer to the "Inverter" section on
page 58.
➤ Lay the two-wire control cables attached to the roof air conditioner to
5.2.6 Installation of the roof air conditioner
It should be ensured that the roof air conditioner is centred perfectly.
A flexible non-hardening sealing compound (e.g. Sika Lastomer-710)
should be applied to the seal before inserting it. The seal must be applied
continuously around the roof air conditioner after placing it on the roof of
the vehicle. This is the only way of safely applying the seal.
➤ Lift the roof air conditioner onto the roof of the vehicle.
Observe the statics of the roof of the vehicle. The roof of the vehicle must
be able to bear the weight of the device. The roof may not be pressed in or
deformed by the weight of the device, also in the long term.
All manuals and user guides at all-guides.com
the necessary current.
the installation location of the charging current distributor.
Observe the direction of travel (arrow, see Fig. 1 on page 3).
Installation
51