Inspection Before Putting The Device Into Service; Setting The Air Nozzles; Switching On The Roof Air Conditioner; Switching To Cooling Mode - Waeco EasyCool EC-1500-AC Instrucciones De Montaje Y Uso

ec_1500_2000.book Seite 54 Freitag, 12. Mai 2006 4:11 16
Operation
6.1

Inspection before putting the device into service

Please observe the following before switching on the EASY COOL roof air
conditioner from WAECO:
Check whether the supply voltage and frequency correspond to the
values specified in the previous section.
Ensure both the air intake opening and the air nozzles are free.
All ventilation grilles must always be kept free to ensure the air
conditioner is able to operate at maximum capacity.
Do not insert any fingers or objects into the air distribution nozzles or the
intake grille.
6.2

Setting the air nozzles

– see Fig. 9 on page 5 –
EC-2000 only:
Never close all of the air nozzles of the roof air conditioner simultaneously.
The device would freeze from within.
The air supply within the vehicle can be regulated by opening or closing
the air nozzles (see Fig. 9 on page 5, E).
➤ Open or close the nozzles to direct the required amount of air where
you want.
➤ Adjust the air outlet angle by turning the nozzles.
6.3

Switching on the roof air conditioner

➤ Turn the ON/OFF switch (see Fig. 9 on page 5, C) to I to switch on the
unit.
✓ Air conditioning starts.
6.4

Switching to cooling mode

➤ Turn the mode switch (see Fig. 9 on page 5, B) to cooling
6.5

Switching to heating mode

➤ Turn the mode switch (see Fig. 9 on page 5, B) to heating
54
All manuals and user guides at all-guides.com
.
.