Installing The Monitor And The Additional Monitor; Installing The Additional Camera (Optional); Wiring - Extel Nova Instrucciones De Uso

b. Installing the monitor and the additional monitor (
1. Attach the wall bracket (2) so that screen is at a height of around 1.60 m.
2. Connect the wires coming from the intercom panel (4).
3. Plug the adapter's wires (3) into the back of the monitor (without connecting it to the mains). Be sure to
respect the polarity (labels + and -).
4. Place the monitor (1) on the wall bracket (2).
5. Plug the power supply plug into the 230 V wall outlet .
Note: If modifying the power chord, be sure to respect the polarity (white border (+) (fig. 7)).
c. Installing the additional camera (optional)
• Connect the wires according to the wiring diagram (fig.6).
• Choose a suitable place to install the camera.
• Ensure that nothing gets in the way of the installation.
• Screw the wall section with the screws provided.
• Screw the camera to the bracket.
• Point the camera in the desired direction and tighten the lateral retainer screw.
• Plug the camera into the videophone system.

5. WIRING

To avoid the risk of interference and malfunctions, do not run the videophone cable through the same sheath as
the electrical cables.
Warning: do not double up the wires to increase the area.
In case of a short-circuit on the line, a protection system is activated. Disconnect and reconnect the power supply
after 10 seconds.
a. Connecting the videophone
Important:
All of the maximum cable length characteristics indicated in the table (fig. 6) must be met at the same time.
Wires to use: • 2 x 0.6 mm wires up to 25 m
• 2 x1.5 mm
1. Connect the wires according to the wiring diagram (fig.6).
2. To connect the camera, only 2 wires are needed for all functions: bell sound, video image, intercom and opening
controls (strike plate and automatic opener).
Be sure to respect the polarity between the screen and the intercom panel (no need to observe polarity for the
door opener control).
• Terminal "1" of the screen on terminal "1" of the intercom panel.
• Terminal "2" of the screen on terminal "2" of the intercom panel.
Important:
• For the wiring, see the label stuck to the back of the monitor and on the back of the intercom panel.
b. Connecting a strike plate or electric lock (fig. 6)
Connect directly to terminals 5 and 6 at the back of the intercom panel (no need to observe polarity).
Note that this function is only available when the screen is displaying the video from out-
side. A light
Important: The strike plate or electric lock that you are about to install must have a mechanical memory, like
all EXTEL products. For the wiring, see the label stuck to the back of the intercom panel.
GB4
(fig. 6)
2 from 5 to 100 m / 125 m
appears as confirmation.
CFI EXTEL NOVA / NOVA WHITE / ICE - 11/2016
fig. 5)