Zanussi ZCAN10FW1 Manual De Instrucciones página 23

Problem
There is too much frost and
ice.
The compressor does not start
immediately after pressing the
SUPER, or after changing the
temperature.
The temperature in the appli-
ance is too low/too high.
Possible cause
Large quantities of food to be
frozen were inserted at the
same time.
The room temperature is too
high.
Food placed in the appliance
was too warm.
The lid is not closed properly.
The SUPER function is switch-
ed on.
The lid is not closed properly
or the gasket is deformed/dirty.
Temperature is set incorrectly.
This is normal, no error has oc-
curred.
The temperature regulator is
not set correctly.
The lid is not closed properly.
The products' temperature is
too high.
Many products are stored at
the same time.
The thickness of the frost is
greater than 4-5 mm.
The lid was opened too often.
The SUPER function is switch-
ed on.
Products to be frozen are
placed too closely to each oth-
er.
Solution
Wait a few hours and then
check the temperature again.
Refer to the climate class
chart on the rating plate or to
the "Installation/Positioning"
chapter.
Allow food to cool to room
temperature before storing.
Check if the lid closes properly
and the gaskets are not dam-
aged or dirty.
Refer to "Control panel/SU-
PER function" chapter.
Check if the lid closes properly
and the gaskets are not dam-
aged or dirty.
Refer to "Control panel/
Temperature regulation" chap-
ter.
The compressor starts after a
period of time.
Set a higher/lower tempera-
ture.
Check if the lid closes properly
and the gaskets are not dam-
aged or dirty.
Allow food to cool to room
temperature before storing.
Store less products at the
same time.
Defrost the appliance. Refer to
"Care and cleacning/Defrost-
ing the appliance" chapter.
Open the lid only if necessary.
Refer to "Control panel/SU-
PER function" chapter.
Make sure that there is cold air
circulation in the appliance.
23