HQ-Power PROMIX502N Manual Del Usuario página 4

1. MIC channel tone controls
These two controls adjust the high and low frequency of the DJ MIC channel and MIC 1/2 (± 12dB).
2. MIC channel level control
This control adjusts the level of the DJ MIC channel and MIC 1/2.
3. talk-over control
This control presets the attenuation level on the main output channels when using a microphone. Attenuation
level: 0dB (off) ~ 14dB.
4. input selectors
Use these selectors to select the input signal. Choose between the stereo CD/phono, line/CD, line/video and
line/tape.
5. cue selector
This switch selects the input signal on the respective channel and routes it to the cue channel on the headphones
and monitor.
6. channel level controls
This fader adjusts the individual input signal level in order to obtain the desired volume level for each channel.
7. output master level 1/2
These knobs adjust the output level of the master output signal.
8. tone controls (high/mid/low)
These 3 rotary knobs are used to adjust the frequency response of the master output signal (± 12dB).
9. balance controls
Adjust the level of the left and right channels with these controls.
10. VU meter
These LED VU meters indicate the left and right levels of the master outputs.
11. power switch
Make sure to set all controls to their minimum position before switching the mixer on or off.
12. headphones level control
This control adjusts the level of the stereo headphones.
13. headphones connection
This is a standard ¼" phone jack.
14. DJ MIC input
This is an XLR/¼" jack combination for microphone connection.
14a. DJ MIC input
These are balanced inputs for microphone connection.
15. phono inputs
These are left and right phono inputs for channels A and B used for connection of a turntable.
16. line inputs
These are line inputs for channels A, B, C, D and E used for connection of a CD player, tape deck, etc.
17. ground connector
This connection is used to connect the earth of the turntable.
18. REC outputs
These connections are used to connect the mixer to a tape recorder.
19. master 2 output
These are unbalanced stereo outputs used to connect the mixer to an amplifier.
20. master 1 output
These are unbalanced stereo outputs used to connect the mixer to an amplifier.
21. fuse
Replace a melted fuse with a fuse of the exact same specifications.
22. power cord input
This is the input connection for the included standard IEC power cord.
PROMIX502N
All manuals and user guides at all-guides.com
4 HQPOWER