Volkswagen 3AB 055 204 Instrucciones De Montaje página 12

Install electrical kit
1. Disconnect negative terminal of battery.
2. Remove the following covers and panelling, as necessary:
In the boot
•
Boot floor cover
Loading sill cover
Panelling on the left-hand side of the boot
On the left side of the vehicle
•
Seats of the rear bench seat
Scuff plates
Left panelling by the steering column
Fuse box cover
3. Remove the cap from the 40 mm hole below the left tail light in the vehicle tail end panel
(Fig. 1/5).
4. Fix trailer connection unit in the space provided on the left-hand side of the boot using the
spring nuts and fixing screws provided (Fig. 1/4)
5. Route the end of the cable with the 16-pin plug and eyelet from outside through the hole to
the trailer connection unit (Fig. 1/4).
6. Insert the rubber grommet in the hole (Fig. 1/5).
7. Route the end of the cable set with the socket to the socket mounting plate (Fig. 1/6).
Fit socket
8. Push contact insert into the socket housing and slide rubber seal up to the socket.
9. Screw the socket onto the mounting plate with the screws provided (Fig. 1/6), torque setting:
max. 2.0 Nm. If necessary shorten screws.
Connect trailer connection unit
10. Connect and lock the 16-way socket housing to the socket provided on the trailer connection
unit (Fig. 1/4).
11. Connect and lock the 12-way socket housing of the 9-core cable set to the socket provided on
the trailer connection unit.
12. The functions "permanent positive", "charge line" and " ground for charge line" can be
retrofitted using the 3-pin plug for the uninterrupted positive pre-installation (Westfalia
Automotive 300 025 300 113).
12
All manuals and user guides at all-guides.com
321 823 391 103 - 002 - 43/11 Passat B7 Limousine & Variant, Coupè