Replace The Fuse - LIMIT 500 Manual De Instrucciones

Replace the fuse

1. Disconnect the connection between the testing leads and the cir-
cuit under test.
2. Turn the Meter to OFF position.
3. Remove the screw and separate the case bottom from the case top.
4. Remove the fuse by gently prying one end loose, and then take
out the fuse from its bracket.
5. Replace only fuses with the identical type and specification as
follows. 0,5A 250V, fast type, 5x20mm.
6. Rejoin the case bottom and case top, and reinstall the screw.
Replacement of the fuses is seldom required. Burning of a fuse
always results from improper operation.
(see figure 5)
12
5 0 0