YUNEEC TYPHOON H Guia De Inicio Rapido

CAUTION: Do not calibrate the compass in parking garages, close to buildings or near roads with a metal core. For optimum
performance, only calibrate the TYPHOON H in open spaces, far away from power lines and other metal structures or concrete buildings.
NOTICE: In order to calibrate the compass in the YUNEEC TYPHOON H, Please be sure to perform the compass calibration procedure
at least 11 feet away from the nearest cell phone or other electronic devices to ensure proper calibration.
STEP 1) Power on the ST16 Ground Station
first and then the aircraft, and make sure they
are connected correctly (If they are not
connected correctly, the telemetry data will
not display on the screen).
STEP 3) Lift the TYPHOON H airframe straight & level. When the LEDs on two motors start to blink blue and green
separately as illustrated, turn it forward as shown by the red arrow above until the two LEDs turn off.
STEP 4) When the LEDs on another two motors start to blink white and red separately as illustrated, turn the aircraft
60° to the left and then turn it forward as shown by the red arrow above until the two LEDs turn off.
STEP 5) When the LEDs on another two motors start to blink white and red separately, Turn the aircraft 60° to
the left again and then turn it forward as shown by the red arrow above until the two LED s t urn off.
STEP 6) When the LEDs on another two motors start to blink green and blue separately, Turn the aircraft 60°
to the left again and then turn it forward as shown by the red arrow above until the two LEDs turn off.
STEP 7) When the LEDs on another two motors start to blink red and white separately, Turn the aircraft 60° to
the left again and then turn it forward as shown by the red arrow above until the two LEDs turn off.
STEP 8) When the LEDs on another two motors start to blink red and white separately, Turn the aircraft 60° to
the left again and then turn it forward as shown by the red arrow above until the two LEDs turn off.
COMPASS C AL IB R ATION
STEP 2) Tap the GPS CALIBRA-
TION icon on the ST16 screen
and choose COMPASS.
If the calibration has been successful, all the
LED status indicators will blink continuously,
the Main LED Status Indicator will be solid
green and the flight controller restarts, you will
recognize this when you hear the acknowl-
edgement tone, the same one you hear when
you switch the system on.
IMPORTANT NOTE: If calibration has failed, the
Main LED Status Indicator will be solid white and
you must repeat the calibration process. If the
calibration continues to fail, either the site of
calibration is unsuitable or the compass is
defective. Refer to your Yuneec service center.
V1.0
GPS
CALIBRATION