Removing (Jcb Robot 150, 160, 165, 170, 185, 190 1105, 1110, 1Cx); Non Jcb Carriers - JCB XR Serie Manual Del Usuario

7
Removing (JCB Robot 150, 160, 165, 170,
185, 190, 1105, 1110 and 1CX)
! ! WARNING
If two people are doing this job, make sure that the
person working the controls is a competent operator. If
the wrong control lever is moved, or if the controls are
moved violently, the other person could be killed or
injured.
2-2-6-5
1 Use the drive control lever to stop and park the
machine on level ground.
2 Use the loader arm control lever to lower the
attachment to the ground.
3 Stop the engine and relieve hydraulic circuit pressure
(see Operator Manual).
4 Push forward the hydraulic safety control restraint bar.
Dismount from the machine or get someone else to
perform steps 5 and 6.
5 If appropriate, disconnect the attachment tail hoses
from the loader arm pipework (see Operator Manual).
Note: The illustration below is typical and does not refer to
a specific machine.
Y
All manuals and user guides at all-guides.com
INSTALLING AND REMOVING
A
Y
X
A1461-1
6 Pull levers X fully out beyond the sides of the hitch
plate A to retract the Quickhitch locking pins Y.
7 Return to the cab seat (or make sure your assistant is
well clear of the Quickhitch). Pull back the Safety
Restraint Bar. The attachment is now ready for use.
8 Operate the loader arm control lever to the right as if
to roll forward the attachment.
9 When the hitch plate A has disengaged from the lips
on the attachment, reverse the machine clear.
Non-JCB Carriers
For Non-JCB carriers reference should be made to the
trenchers mechanical and hydraulic specifications. Refer to
the carriers Owners Manual for instructions on installing
and removing attachments. However the following general
points should be observed.
1 Position the trencher on firm, flat ground.
2 Make the carrier safe, e.g. parking brake engaged,
engine stopped, hydraulic pressure released.
3 Use adequate lifting equipment.
7
0876