Travelling With The Trencher; On Site; On A Truck - JCB XR Serie Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

12

Travelling with the Trencher

The safe transit of the load is the responsibility of the
transport contractor and driver. Any machine,
attachments or parts that may move during transit
must be adequately secured.
5-2-5-9
Note: Before transporting the machine make sure you will
be obeying the rules and laws of all the areas that the
machine will be carried through.
Make sure that the transporting vehicle is suitable. See
Static Dimensions (SPECIFICATIONS section of the
Carrier Owners Handbook) for the dimensions of your
machine.
! WARNING
!
Before moving the machine onto the trailer, make sure
that the trailer and ramp are free from oil, grease and
ice. Remove oil, grease and ice from the machine tyres.
Make sure the machine will not foul on the ramp angle.
See Static Dimensions in SPECIFICATIONS section for
the minimum ground clearance of your machine
2-2-7-5/1

On Site

Raise the carrier loader arm so that the attachment is
approximately 200 mm (8 in) above the ground. When
moving around the site follow as level a route as possible.
! WARNING
!
Never travel at excessive speed over rough terrain. The
resulting loss of control could cause the carrier to tip
over. This could lead to death or serious personal injury
as well as damage to the attachment and/or carrier.
B-1-2-11
All manuals and user guides at all-guides.com
OPERATION
A1461-1

On a Truck

! WARNING
!
Water, mud, ice, grease and oil on ramps or trailers can
cause serious accidents. Make sure ramps and trailers
are clean before driving onto them. Use extreme
caution when driving onto ramps and trailers. Always
reverse up a ramp if unloaded, travel forwards if loaded.
Always reverse down a ramp if loaded, travel forwards
if unloaded.
3-1-1-3
1
Drive the carrier up the ramps and onto the truck after
proceeding as described for On Site.
a If the attachment is being transported alone, lower
the assembly to the floor of the truck. Remove
from the machine (see Removing - JCB Robot
150, 160, 165, 170, 185, 190, 1105, 1110 and
1CX) and drive the carrier off the truck. Secure the
attachment to the truck using straps or chain of
sufficient strength.
b If the attachment is being transported with the
machine, lower the assembly to the floor of the
truck and switch off the engine. Block the wheels
and using the attachment points chain the carrier
to the bed of the truck as shown in the illustration.
12
0879

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Xr-35Xr-21Xr-14

Tabla de contenido