Emptying The Dust Container; Cleaning The Exhaust Filter; Cleaning The Dual Motor Protection Filter - Royal Infinity VS8 Loop Manual De Instrucciones

All manuals and user guides at all-guides.com
Infinity VS8 Loop_3-sprachig.book Seite 7 Donnerstag, 4. Juni 2009 3:00 15
4 Maintenance

4.1 Emptying the dust container

Empty the dust container after each
vacuuming session, but at the latest when the
"MAX" mark (Fig. 17/1) has been reached.
ATTENTION:
Switch off the appliance before emptying the
dust container. This will prevent dust from
damaging the appliance.
1. Remove the dust container by pushing the
release button (Fig. 17) and then remove
the dust container from its console.
1
17
2. Empty the dust container by holding it low
over a dust bin and only then push the
release catch of the bottom plate (Fig. 18/
A1).
A B
1
18
NOTE:
You can dispose of the dust filter bag with
your regular domestic trash as long as it
contains no waste materials prohibited in
domestic trash.
3. On this occasion, also take out the cyclone
unit by unlatching it as shown (Fig. 18/B,
the arrow will move from to ).
4. Remove any residual dust that may have
collected in the dust compartment.
5. Clean the cyclone unit by wiping it with a
dry cloth or by brushing it with a dry soft
brush, e.g. the furniture brush supplied with
the appliance.
6. Replace the cyclone unit and secure it by
turning clockwise (the arrow will move from
to ).
7. Fold the bottom plate back up.
8. Also check the dual motor protection filter
on this occasion. Clean it if necessary,
chapter 4.4, „Cleaning the dual motor
protection filter".
9. Put the dust container back into its holder.
You must feel and hear it click into place.
Infinity VS8 Loop
4.2 Overview of the filters
The filters can get dirty during use and
therefore must be checked regularly:
Keep the checking and cleaning intervals
given below.
Clean the filters as described below.
Damaged or deformed filters, however,
must be replaced immediately.
The following 2 filters are installed:
1
2
19
Dual motor protection filter (Fig. 19/1)
- Checking: Check the dual motor
protection filter for dirt and possible
damage every time you empty the dust
container.
- Cleaning If during checking you see that
the filter is dirty, clean it as described
below ( chapter 4.4, „Cleaning the dual
motor protection filter"). However, the
filter should be cleaned at least every 3 –
6 months.
Exhaust filter (Fig. 19/2)
- Checking: Check the exhaust filter
regularly for dirt and possible damage, at
least every 3 – 6 months.
- Cleaning: If during checking you see that
the filter is dirty, clean it as described
below.

4.3 Cleaning the exhaust filter

1. Switch off the appliance.
2. Push the release catch of the exhaust filter
cover to the side and fold down the exhaust
filter cover (Fig. 20).
20
3. Remove the exhaust filter.
4. Clean the hygienic exhaust filter by tapping
out the dirt over a dustbin. Should this be
insufficient, clean the the filter with a soft
brush, e.g. the furniture brush supplied with
the appliance.
If this dry cleaning is still insufficient, then
rinse the filter in clear cold water.
Maintenance
ATTENTION:
The filter is washable, but not suitable for
cleaning in washing machines or
dishwashers. Also, do not use cleansers for
cleaning the filters. Leave the filter element
to dry after cleaning (approx. 24 hours at
room temperature). Only put it back into the
appliance when it is completely dry.
5. If the filter is damaged or deformed, replace
it. ( chapter 6, „Spare parts").
6. Put the clean exhaust filter back into its
holder.
7. Attach the exhaust filter cover at the bottom
side first and then fold it shut.
8. To secure it you must guide the latch by
hand as during unlatching until you hear
and feel it snap into place.
4.4 Cleaning the dual motor
protection filter
1. Switch off the appliance, remove the dust
container and empty it chapter 4.1,
„Emptying the dust container".
2. Open the latch of the motor protection filter
cover and take out the dual motor
protection filter (Fig. 21).
21
3. Hold the dual motor protection filter deep
inside a dustbin and only then separate the
filter elements from each other.
4. Thoroughly rinse both filter elements by
hand with clear cold water.
ATTENTION:
The filter elements are washable, but not
suitable for cleaning in washing machines or
dishwashers. Also, do not use cleansers for
cleaning the filters. Then leave the filter
elements to dry (approx. 24 hours at room
temperature). Only put them back into the
appliance when they are completely dry.
5. If a filter element is damaged or deformed,
replace it by a new one. ( chapter 6,
„Spare parts").
6. Put the filter elements back together again.
7. Close the motor protection filter cover by
folding it shut. The latch must snap shut.
8. Put the dust container back into the
appliance. It must catch with a click.
7