Start-Up; Working - ST MP 500 Li 48 Manual De Instrucciones

6.2.1 General safety check
Object
Grip and guards
Screws on the
machine and blade
Cooling air ducts
Guide rod
Chain
Guards
Battery
Machine
Throttle trigger lever,
throttle lock lever
Test
driving
6.2.2 Machine operating test
Action
Fit the battery inside
its housing (par. 7.2.3).
Activate the throttle
trigger lever. (without
pressing the throttle
lock lever)
Press the throttle
lock lever and throttle
trigger lever.
Release the throttle
trigger lever.
If any of the results fail to match the
instructions provided in the tables, do not
use the machine! Contact a service centre to
have it checked and repaired if necessary.
Result
Clean, dry and fixed
firmly to the machine.
Correctly tightened
(not loose)
Not clogged
Properly installed
Sharp, not damaged
or worn, mounted and
tensioned correctly.
Intact, undamaged.
No damage to
the casing, no
liquid leakage
No signs of
damage or wear
The levers must
move freely and
not be forced.
No abnormal
vibrations.
No abnormal sound
Result
The chain should
not move
The throttle trigger
lever remains blocked.
The levers must
move freely and
not be forced. The
chain moves.
The lever automatically
and rapidly returns
to the idle position.
The chain should stop.

6.3 START-UP

6.3.1 Start-up with battery
1. Remove the protection bar cover (Fig. 1.J).
2. Make sure the bar and the chain are not
touching the ground or any other object.
3. Fit the battery inside its housing
correctly (par. 7.2.3).
4. Press the safety button
5. Activate the throttle lock lever (Fig. 14.B)
and the throttle trigger lever. Fig. 14.A).
6.3.2 Start-up with battery
simulator (if provided)
1. Remove the protective bar cover (Fig. 1.J).
2. Make sure the bar and the chain are not
touching the ground or any other object.
3. Insert the battery simulator correctly into
its housing on the machine (Fig.17.O).
4. Connect the connection cable to
the battery simulator (Fig.17.N).
5. Select the battery to be operated
using the selector switch (Fig. 13.B).
6. Press the safety push-button
(blue light) (Fig. 14.C).
7. Press the throttle lock lever (fig. 14.B)
and throttle trigger lever. (fig. 14.A).

6.4 WORKING

Before delimbing for the first time, make sure:
– to have been specifically trained
to use this type of equipment;
– to wear the harness correctly;
– to have carefully read the safety
regulations and user instructions
contained in this manual;
– you practise first on logs on the ground
or attached to trestles, in order to
get familiar with the machine and the
most suitable cutting techniques.
To use the machine proceed as follows:
• always keep the machine connected
to the correctly worn harness when
working (see paragraph 6.1.2).
• The machine must always be
firmly held in both hands .
Stop the machine immediately
if the chain stops during sawing.
NOTE During use, the battery is
protected against total drainage with a
EN - 10
Fig. 14.C ;
( )