Fagor 7CFI-5GLSTA Manual Del Usuario página 49

Maintenance vitroceramic surface
(Fig.-2) First of all remove stray food bits and grease drops from the cooking surface with the special scraper (fig. 2).
Then clean the hot area as best as possible with SIDOL, STAHLFIX or other similar products with a papertowel, then
rinse again with water and dry with a clean cloth.
Pieces of aluminum foil and plastic material which have inadvertently melted or sugar remains or highly sacchariferous
food have to be removed immediately from the hot cooking area with the special scraper (fig. 2). This is to avoid any
possible damage to the surface of the top.
Under no circumstances should abrasive sponges or irritating chemical detergents be used such as oven sprays or
spot removers.
Do not use steam cleaning appliances to clean the cooking surface.
Fig. 2
INSTRUCTIONS FOR THE INSTALLER
Installation
This appliance is not provided with a combustion product discharge. It is recommended that it be installed in sufficiently
aerated places, in terms of the laws in force. The quantity of air which is necessary for combustion must not he below
2.0 m 3 /h for each kW of installed power.
See table of burner power.
Positioning
The appliance can be fitted into a working area as illustrated on the corresponding figure. Before positioning the hob,
fit the seal around the entire peripnery of the hole cut in the worktop.
Fig. 3
All manuals and user guides at all-guides.com
49